How to connect capsule electrical slip ring wire？

The wiring methods of cap-type conductive slip rings can vary according to specific applications and circuit requirements. Generally speaking, the wiring methods of hat-type slip rings can be divided into the following types:

Plug type wiring: Insert the plug part of the cap slip ring into the equipment and then connect it to the circuit through the wire. This method is suitable for occasions where frequent replacement or maintenance of slip rings is required, but good contact between the plug and socket needs to be ensured.

Welded wiring: Weld the lead part of the cap slip ring to the device and then connect it to the circuit through wires. This method is suitable for occasions where the position of the slip ring needs to be fixed, but the surface finish of the equipment needs to be ensured.

Terminal type wiring: Connect the lead part of the hat-type slip ring to the terminal board, and then connect it to the circuit through the terminal board. This method is suitable for occasions that require multiple signal outputs, but you need to select appropriate terminal boards and wires.

It should be noted that no matter which wiring method is used, you need to pay attention to safe operation to avoid accidents. At the same time, during the installation and wiring process, it is necessary to carefully check whether the leads and connection methods of the capsule electrical slip ring are correct to avoid problems such as poor connection or short circuit.

RELEVANT INFORMATIONS